Buy Jem Glaciator X-Stream Heavy Fog Machine

Products
   Smoke Machines
   Hazers
   Specialist

   Smoke Fluid
   Special Effects
   Smoke Pellets

Sales / Hire
   Applications
   How to order
   Hire
   Q & A

About us
   Who we are
   Contact

Your Basket

BUY SMOKE MACHINES

Jem Glaciator X-Stream Heavy Fog Machine

Heavy fog without the need for dry ice or CO2 - all that's needed is power and fluid!

There’s no doubt about it! A stage covered with a blanket of white, dense low lying fog is a dramatic and classical theatrical effect. However, when touring the effect is all too often edited from productions because dry ice is too difficult to source, impossible to store and very messy to use, requiring gallons of boiling water to activate the fog effect. There is another problem as well - dry ice isn’t dry. Performers often have to contend with wet and slippery stages.

The Glaciator X-Stream houses a remarkably powerful compressor, allowing colossal fog output levels. And because of its advanced, electronically controlled expansion valve, it has a rapid freeze down time and a fast recovery when fired. This means the Glaciator X-Stream runs continuously, - almost infinitely, with a cool ease.

Made in England

Its chassis design; with two high velocity fans and smart-flow ventilation, also keeps the Glaciator X-Stream ticking in environments of high ambient temperatures. And keeping an eye on internal components is done with an unparalleled simplicity using the Glaciator X-Stream’s Internal Diagnostic Assistance.

Featuring a Power Save System when passive, The Glaciator X-Stream is conscientiously efficient with energy and sound, and its cooling fans have a low noise operation when idle, benefiting theatrical and Studio applications.

The Glaciator X-Stream also has the option of an external fluid supply; allowing voluminous levels of heavy fog fluid to be stored up to 100 meters away from the unit and at a depression of up to 6 meters.

Where silence is golden and space is rare, the Glaciator X-Stream’s remote ducting system allows you to place the unit up to 10 meters away from its application area. A great solution, the remote access system does not in any way compromise the Glaciator’s X-Stream fog output density!

Features:

No need for a separate fog generator - Glaciator is completely self contained!
No need for separate gas cylinders or Dewar vessels
3500W heat exchanger (3-phase power reqd)
1HP (34cc) compressor for max cooling
10 min heat up time
5 litre fluid capacity
80m²/min smoke output
On-board control panel
Fog and fan control
Run and delay time control
On-board 2 channels 3 pin DMX
DMX link
Internal or external fluid supply

Specifications - PDF document

ON-BOARD LED DISPLAY
This 3 digit LED user interface allows you full and user-friendly access to the different functionalities of the unit.

On-Board DMX
With onboard DMX you will have access to the machine from any DMX controller or desk.

DIRECT THERMAL PROTECTION DEVICE (DTPD)
This small yet crucial component is the last line of defence against catastrophic failure. This machine's DTPD is made from a solid ceramic composite. This guarantees extremely precise overheat monitoring and is unaffected by ambient temperature changes.

Electronic Pump Ramping (EPR)
EPR is an intelligent means of warning of a drop in temperature which could result in 'wet smoke' (residue). The pumps respond to this signal by running slower and pumping less fluid, thus allowing the heaters to restore optimum operational temperature. This guarantees a continuous flow of smoke using highly efficient, lower wattage heaters.

Electronic Low Fluid Cut-off System
This technology is fitted to all machines designed for continuous operation. To eliminate the risk of running dry and burning out the pump, this unique electronic sensing system will automatically shut-off the machine, protecting all major components.

D-Tec Vaporizing System
This unique system produces a very high smoke output using a relatively low wattage heat source. The secret is its high alluvial mass and its twin, cuprous, oval helicoils. 3.5 metre helicoils and precision casting ensure maximum heat exchange between the efficient 1500-watt heater and the twin fluid carrying coils.

Fluid Container (9.5 litre)
The removable container makes for quicker refills and protects the machine from damage through spillage in transit.

Heat Exchangers (3500W)
All Jem heat exchangers are designed for high efficiency performance. Only the purest grade LM24 aluminium is used in the production process which eliminates the risk of porosity (pockets of gas within the casting which can cause heater failure). All heat exchangers contain cuprous helicoils of at least 2.8 metres in length, ensuring a continuous flow of pure, dry, white smoke.

Download user manual

Editor's note:
The Glaciator X-Stream allows you to create heavy fog without any dry ice or CO2. All you need is power (3 phase) and smoke fluid.