DMX
512 as standard
The ORKA can be controlled via DMX 512. The
connection is done with 5pin-XLR-plugs.
The DMX start address can be adjusted and saved via the control
panel.
If an external fan is connected to the machine
it can be controlled separately via DMX as well and can be
used as a wind machine.
The machine can also be controlled with analog
(0 - 10 V) via a lighting desk or via XLR-remote (option).
This connection is done with 3pin-XLR-plugs.
A stand-alone-mode is also possible. The adjustments
are done directly at the machine. A short press at the start
button makes the machine run. Therefore a permanent pressing
of the start button is unnecessary.
Internal timer
With the internal timer the fog time can be
exactly adjusted in seconds, the wait time in minutes and
the output in %.
Control panel
The control panel with LED-display, simple symbols
allow for easy operation. It also protects the control buttons
against dirt.
Finest adjustments of the output
Digital technology makes fine adjustment of
the pump possible. In steps of 1% the output can be adjusted
from 0 - 99%. Thus, any desired effect from a tiny fog-cloud
to the thickest fog can be produced. This enables the Orka
to be used in both small and large locations.
Connector for external fan
An external fan with max. 800 Watt can be connected
to the ORKA. Once connected to the machine, the fan can also
be adjusted via DMX. The machine then uses two following channels
at the desk.
Advantages
DMX as standard, analog and stand-alone-mode
Internal timer
Fog and air output adjustable in steps of 1% (0 - 99%)
Continuous output
Easy handling
Very powerful output
Connector for external fan up to 800 Watt
Made in Germany |