DIRECT THERMAL PROTECTION DEVICE (DTPD)
This small yet crucial component is the last line of defence
against catastrophic failure. This machine's DTPD is made from a solid
ceramic composite. This guarantees extremely precise overheat
monitoring and is unaffected by ambient temperature changes.
Electronic Pump Ramping (EPR)
EPR is an intelligent means
of warning of a drop in temperature which could result in
'wet smoke' (residue). The pumps respond to this
signal by running slower and pumping less fluid, thus allowing
the heaters to restore optimum operational temperature. This
guarantees a continuous flow of smoke using highly efficient,
lower wattage heaters.
Soft Start Electronics
The 'crack' created during the initial burst of smoke is caused
by the pump pressure overcoming the incredible back pressure
of the heat exchanger. The unique Soft Start Electronics in this machine
gradually powers the pump, eliminating this crack and ensuring
a quieter and smoother operational level following initial
start up.
Compact Timer Remote
A hand-held remote that is safe, user friendly, low voltage
remotes which offers precision auto-timer and output level
controls. The auto-timer is simple to set with 'Fog On' adjustable
between 0 and 15 seconds, while the delay period is pre-set
at 1 minute.
Fluid
Container (1 litre)
Designed to carry a 1 litre removable fluid container. The
removable container makes for quicker refills and protects
the machine from damage through spillage in transit.
Heat Exchangers (750W)
Designed for high efficiency performance, only the purest
grade LM24 aluminium is used in the production process which
eliminates the risk of porosity (pockets of gas within the
casting which can cause heater failure). All heat exchangers
contain cuprous helicoils of at least 2.8 metres in length,
ensuring a continuous flow of pure, dry, white smoke.
Download
information sheet (PDF)
Download
user manual (PDF) |